Hobby Components USBASP AVR Programmer and Adapter

Features:
Compatible with most types of Atmel AVR microcontrollers (see list)
Standard 10 pin ICSP header
Included ICSP cable for solderless connection to your development board
Included 10 to 6 pin adapter
Configurable 5V and 3V power supply
LED power and programming indicators
Compatible with AVRDude and Arduino IDE

Supported devices:
ATMega
ATmega168 ATmega168A ATmega168P ATmega168PA ATmega328 ATmega328P ATmega103 ATmega128 ATmega128P ATmega1280 ATmega1281 ATmega16 ATmega16A ATmega161 ATmega162 ATmega163 ATmega164 ATmega164A ATmega164P ATmega164PA ATmega169 ATmega169A ATmega169P ATmega169PA ATmega2560 ATmega2561 ATmega32 ATmega32A ATmega324 ATmega324A ATmega324P ATmega324PA ATmega329 ATmega329A ATmega329P ATmega329PA ATmega3290 ATmega3290A ATmega3290P ATmega64 ATmega8 ATmega8A ATmega48 ATmega48A ATmega48P ATmega64A ATmega640 ATmega644 ATmega644A ATmega644P ATmega644PA ATmega649 ATmega649A ATmega649P ATmega6490 ATmega48PA ATmega88 ATmega88A ATmega88P ATmega88PA ATmega6490A ATmega6490P ATmega8515 ATmega8535

ATTiny
ATtiny12 ATtiny13 ATtiny13A ATtiny15 ATtiny25 ATtiny26 ATtiny45 ATtiny85 ATtiny2313 ATtiny2313A

Older Devices
AT90S1200 AT90S2313 AT90S2333 AT90S2343 AT90S4414 AT90S4433 AT90S4434 AT90S8515 AT90S8535

Pinouts:
USBasp:
10 pin IDC
1)…………..MOSI
2)…………..VCC (5V/3.3V via JP1)
3)…………..GND
4)…………..TXD
5)…………..RESET
6)…………..RXD
7)…………..SCK
8)…………..GND
9)…………..MISO
10)…………GND

JP1: Target power supply jumper. Selects between 3.3V and 5V power supply to target board.
JP2: Self programming mode. Short to reprogram USBasp firmware
JP3: Slow clock mode. Short if target clock is lower than 1.5MHz
R LED: Illuminated when programming device.
G LED: Power indicator.

Libusb Drivers available on our support forum.

A compact USB in-circuit programmer (HCDVBD0031) specifically designed to program most versions of Atmel AVR microcontrollers. The programmer plugs straight into a USB port on your computer and features the standard Atmel 10 pin ICSP IDC header. With the included IDC cable this allows it to connect directly to many types of Atmel development boards.
We have also included a 10 to 6 pin adapter to allow it to be compatible with the standard 6 pin ICSP header. This includes most types of Arduino development boards such as the Uno, Nano, Mega, etc.
Additionally we have reprogrammed the firmware to allow it to be directly compatible with the Arduino IDE (simply select Tools->Programmer->USBasp) – the standard firmware is NOT compatible with the latest versions of the Arduino IDE.
List of Features, supported devices etc can be seen further down the page.
Libusb Drivers available on our support forum.